Brocket Classified Ad Listings

Hey all, freshing up a '15 and was curious about the Pedders HD Strut Mounts. I can't find any reviews on them. Anyone there have them and can provide some information? Curious about NVH, quality, and performance improvement (if any). Thanks in advance.

Case tractor weights Tractor weights and brackets off Case 1370. 4 weights and the brackets.

Mainsail for a J/30 Sailboat. Has been stored indoors for 10+ years, appears to have only had light use and is in very good condition. Measurements laying on the ground (so not stretched out) are P (mast side) 36', E (boom side) 12.5'; stretched out I suspect will measure a bit more. Sail manufactured by Melges Sails, Zenda, Wisc. Includes original sail bag. $450 (plus shipping if necessary) St...

Looking for a 13-14 Gt or boss. Manual, turbo. Black, white or green. Preferably built trans and motor. (Gen 2 and 3 motors are fine). Closer to Michigan the better.

Case IH Concave 1 small wire, has bolt on extension

Sprayer Wind Screens Wind screens off a Summers sprayer. 80ft.

Fertilizer meters JD 7000 planter

Anhydrous NH3 tubes Bolt on behind spike or sweep. 37 tubes. Fits 3/8 hose.

Shappell DX4000 ice house DX4000 ice house. Used once. Stored in heated garage.

Looking for a pair of good used original nuts for the 216 valve cover brass hold down brackets.

Offy Valve Cover very good condition. One small scratch in front from where I needed to clearance cover for stat housing not seen when installed. $300 + shipping